Article Number: 000181753
If an SP is in service mode, the SP cannot service host I/O. Service mode is necessary during an SP hardware component replacement or when it is necessary to stop servicing I/O by one SP.
How to place an SP into service mode using one of the two methods listed below:
1. Unisphere GUI
The example below is for SPB.
In the Service tab, navigate to "Service Tasks". For the SP that must be put into service mode, select "Enter Service Mode" and then "Execute".
A pop-up window opens and prompts for the service password. The SP reboots into service mode.
2. SSH/CLI
SSH into the SP to place the SP into service mode, set the rescue counter, and then reboot the SP.
Set the user rescue counter: spa:~/user# svc_rescue_state -s NOTE: The below shutdown command may not respond as expected to a typo. If you try to shutdown the peer SP, and you mistype the command, the command may proceed to shutdown the current SP instead. Double-check the syntax before you press enter. Pay attention to case sensitivity as well. Reboot the peer SP using the following command: "svc_shutdown -r sp[x]" where x is "a" or "b". The command should be: spb:~/user# svc_shutdown -r spa or spa:~/user# svc_shutdown -r spb Reboot the same SP as logged into: Example below is to reboot spa from the spa prompt: spa:~/user# svc_shutdown -rHow to clear service mode on an SP using one of the two methods listed below:
Display the rescue counters of an SP: svc_rescue_state -l Clear the counters: svc_rescue_state -c Check the count column to ensure all counters have been cleared: svc_rescue_state -l NOTE: The below shutdown command may not respond as expected to a typo. If you try to shutdown the peer SP, and you mistype the command, the command may proceed to shutdown the current SP instead. Double-check the syntax before you press enter. Pay attention to case sensitivity as well. Reboot the peer SP using the following command: "svc_shutdown -r sp[x]" where x is "a" or "b". The command should be: spb:~/user# svc_shutdown -r spa or spa:~/user# svc_shutdown -r spb Reboot the same SP as logged into: Example below is to reboot spa from the spa prompt: spa:~/user# svc_shutdown -rIf there are any questions or concerns with any points in this KB, contact Dell Support for further assistance.
When monitoring the boot sequence of an SP, one of the following messages displays at the end of the boot sequence. The event message depends on whether the SP is booting into service mode or into normal mode.
CLI command to monitor a peer SP boot:
spa:~/user# svc_diag --monitor-peer
Event message for service mode: ... 08:07:05 : 0x02000003 (O/S running) 08:07:25 : 0x02000004 (OS Blade Being Serviced) Event message for normal mode: ... 07:40:11 : 0x02000002 (Application running) 07:40:29 : 0x00 (Software Component Code...) : 0x18 (iSCSI Zones Daemon - Application Starting)
See Article Number: 000009281 for full instructions on how to monitor a peer SP reboot.
Dell Unity: How to monitor the peer SP boot sequence (Dell Correctable)
Dell EMC Unity Family
01 Feb 2024
5
How To